Professional Equipment
PL259 UHF Male Straight Connector Clamp Solder Attachment for LMR240 Cable
$ USD
Applications
Suitable for a wide range of RF systems, including:
-
01
Antennas
-
02
Military
-
03
Distributed Antenna Systems (DAS)
-
04
Public Address Systems
-
05
Low-Frequency Applications
Product Introduction
The UHF connectors are general purpose units developed for use in low frequency systems from 0.6 - 300 MHz.
Invented for use in the radio industry in the 1930’s, UHF is an acronym for Ultra High Frequency because at the time 300 MHz was considered high frequency; this UHF male connector has an interface type of LMR240 cable and a 50ohm impedance, attachment method uses shield/contact clamp/solder, its straight body is brass with ternary alloy plating.
UHF Connector Features
- Can terminate to coax or terminal;
- Can be male, female or sexless gender with 50ohm impedance
- Body can be straight or right angle
- Mount Method can be 4 hole flange, bulkhead, 4 hole panel or mountless options
- Attachment methods include clamp/solder, crimp/solder, field replaceable or solder
- Body is brass or zinc
Product Specifications
Here are the key attributes of this product.
| ELECTRICAL DATA | |
|---|---|
| Impedance | Not defined |
| Frequency range | DC-300MHz |
| Dielectric withstanding voltage (at sea level) | 1500Vrms, 50Hz between any two contact |
| Insulation resistance | ≥100000MΩ |
| Contact resistance | Inner conductor: ≤2mΩ Outer conductor: ≤2mΩ |
| MECHANICAL DATA | |
| Coupling nut torque | 7Ncm-28Ncm / 0.6 in.lbs-2.5 in.lbs |
| Coupling nut retention force | ≥450N / 101.2 lbs |
| Durability (matings) | ≥500 |
| ENVIRONMENTAL DATA | |
| Temperature range | -50°C to +125°C |
| MATERIAL DATA | |
| Bodies | Brass--Nickel/Ternary alloy plating |
| Pin contacts | Brass-Au plating |
| Socket contacts | Copper-beryllium alloy-Au plating |
| Crimp ferrules | Copper-Ternary alloy plating |
| Insulator | ETFE |
| Gaskets | Silicone rubber |
